300 V6-3.5L (2008)
7. Remove the tape securing the door glass in its full up position, then lower the glass to engage it into the two window regulator glass clamps (2).
8. Using the regulator, lower the glass far enough to access the two window regulator glass clamp screws (3).
9. Tighten the screw in each of the glass clamps. Tighten the screws to 10 Nm (90 in. lbs.).
10. With the upper screw hand-started into the pull cup bracket (1), position the screw into the keyed hole on the inside of the rear door.
11. Install and tighten the screw (2) that secures the bottom of the pull cup bracket to the U-nut (3) on the inside of the rear door. Tighten the screw to
11 Nm (100 in. lbs.).
12. Tighten the screw that secures the top of the pull cup bracket to the inside of the rear door. Tighten the screw to 10 Nm (90 in. lbs.).
13. Reinstall the glass channel and bracket onto the inside of the rear door. See: Windows and Glass/Windows/Window Track/Service and
Repair/Rear Door Glass Run Channel - Installation.
14. Reinstall the watershield onto the inside of the rear door. See: Rear Door Panel/Service and Repair/Rear Door Watershield/Installation.
15. Reinstall the inner belt weatherstrip onto the rear door.
16. Reinstall the trim panel onto the inside of the rear door. See: Rear Door Panel/Service and Repair/Rear Door Trim Panel/Installation.
