300 V6-3.5L (2008)
1. Check to be certain that the energy absorbing cartridge (1) is properly installed and in good condition on the inside of the A-pillar (2). Replace the
cartridge if any damage is evident. Tighten the screws (3) to 3 Nm (25 in. lbs.).
2. Check to be certain that the grommet (2) for the front tether of the side curtain airbag is properly installed and in good condition. Replace the
grommet if any damage is evident. See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Side Curtain Airbag - Removal.
3. Engage the base of the A-pillar trim (1) to the end of the instrument panel top cover.
4. Align the two spring clip retainers on the trim with the slots in the inner A-pillar (3).
5. Using hand pressure, press firmly and evenly forward on the trim over each of the spring clip locations until the retainers snap into place.
Removal
LOWER
1. Loosen the front door sill portion of the lower cowl trim at the rear of the front door opening for access to the forward lower B-pillar trim screw.
See: Cowl Trim/Cowl Trim - Removal.
