300 V6-3.5L (2008)
Seat Heater Switch: Service and Repair
Heated Seat Switch - Removal
Front Seats
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the ash receiver (1) from the instrument panel, See: Interior Moulding / Trim/Ash Tray/Service and Repair/Removal.
3. Disconnect the heated seat switch connector (2) from the heated seat switch (3).
4. From the back of the ash receiver (1), gently pry the switch (3) free and push the heated seat switch out through the front of the bezel.
Rear Seats
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Using an appropriate flat bladed tool, remove the heated seat switch/modules (5) from the console (2) by gently prying up from the edge of the
switch/module bezel (4). Take care not to scratch or damage the console or bezel in any way.