300 V6-3.5L (2008)
5. Remove banjo bolt (4) connecting flexible brake hose (3) to caliper (1). There are two sealing washers (2) (one one each side of hose fitting) that
will come off when bolt is removed. Discard these washers; install NEW washers on installation.
6. While holding guide pins from turning, remove caliper guide pin bolts (2).
7. Remove brake caliper (1) from brake adapter (3) and pads.
Front Single Piston Caliper
REMOVAL
NOTE: Before proceeding, See: Service Precautions/Brakes - Caution.
1. Disconnect and isolate battery negative cable (2) from battery post.
2. Using a brake pedal holding tool, depress brake pedal past its first inch of travel and hold it in this position. Holding pedal in this position will
isolate master cylinder from hydraulic brake system and will not allow brake fluid to drain out of brake fluid reservoir while brake lines are open.
