300 V6-3.5L (2008)
8. Raise and support vehicle.
9. Install screw (6) and routing clip (4) nuts fastening cable (7) to underside of body (3).
10. Route cable above rear crossmember, then slide cable end (1) (shown with connector) and housing (3) through equalizer (2) above rear axle
differential.
NOTE: Due to short travel and low spring tension, it is not necessary to lock-out parking brake lever to service parking brake components.
11. Connect front parking brake cable (5) at connector (3) to right rear parking brake cable (4) (axle differential not shown).