300 V6-3.5L (2008)
Coolant Line/Hose: Service and Repair
Removal
3.5L ENGINE
WARNING: Do not remove pressure cap with system hot and under pressure because serious burns from coolant can occur.
1. Drain cooling system See: Service and Repair.
2. Remove upper and lower intake manifold See: Engine/Intake Manifold/Service and Repair/Intake Manifold - Removal and See: Engine/Intake
Manifold/Service and Repair/Intake Manifold - Removal.
3. Position lower intake manifold upside down on bench and remove the tube retaining bolt (5).
4. Remove heater supply tube (4) from manifold and discard O-ring (2).