300 V6-3.5L (2008)
2. Install the crankshaft (4) to cylinder block (7)
3. Move crankshaft forward to limit of travel. Lubricate and install the front thrust washer (1) by rolling the washer (1) onto the machined shelf
between the No. 2 upper main bulk head and crankshaft thrust surface.
4. Move crankshaft rearward to limit of travel. Lubricate and install the rear thrust washer by rolling the washer onto the machined shelf between the
No. 2 upper main bulk head and crankshaft thrust surface.
5. Install lower main bearings (3) into main bearing caps (1).
6. Lubricate lower main bearings (3) with clean engine oil.
NOTE: Lubricate main bearing cap bolts (2) with engine oil before installation.
