300 V6-3.5L (2008)
Engine Block Heater: Service and Repair
Engine Block Heater - Installation
2.7L/3.5L ENGINE
1. Thoroughly clean cylinder block heater cavity.
2. Insert heater assembly (1) into block (2) with mounting hole is located below heater terminals.
3. Install mounting screw and tighten to 12 Nm (105 in. lbs.).
4. Attach power cord to heater.
CAUTION: To prevent damage, the power cord must be secured in its retainer clips, and not positioned so it could contact linkages or
exhaust manifolds.
5. Lower vehicle.