300 V6-3.5L (2008)
Oil Cooler: Service and Repair
Engine Oil Cooler - Installation
INSTALLATION
1. Position oil cooler to fitting on oil pan.
NOTE: Remove all oil and debris from the seal retainer surface. The cut out section of the oil cooler seal retainer flange (top), must be
aligned with the tab on the oil pan. The oil cooler must be prevented from turning during the tightening sequence.
2. Install oil cooler (1) attaching fastener and tighten to 61 Nm (45 ft. lbs.).
3. Install oil filter (3) and tighten to 12 Nm (106 in. lbs.).
4. Connect coolant hoses to oil cooler (2).
5. Fill cooling system.