300 V6-3.5L (2008)
7. Position the blend door actuator (1) into the vehicle.
8. Install the blend door actuator onto the passenger side of the HVAC air distribution housing (2). If necessary, rotate the actuator slightly to align
the splines on the actuator output shaft (3) with those on the blend door cam (4).
9. Install the screws (1) that secure the blend door actuator (2) to the air distribution housing (3). Tighten the screws to 2 Nm (17 in. lbs.).
10. Connect the HVAC wire harness connector (4) to the blend door actuator.
11. Install the glove box into the instrument panel See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and Repair/Instrument
Panel Glove Box - Installation.
12. Reconnect the negative battery cable.