300 V6-3.5L (2008)
Spot Lamp: Service and Repair
Spot Lamp - Police - Installation
Spot Lamp
INSTALLATION
1. Position bulb into spot lamp assembly.
2. Install the hold downs.
3. Connect the electrical connector to the spot lamp head assembly.
4. Tilt the sealed beam (2) toward the spot lamp head assembly.
5. Install the bezel to the spot lamp head assembly.
6. Install the screws (1) retaining the bezel to the spot lamp head assembly.
7. Lower the spot lamp from the operating to stowed position.
8. Install the fuse and PDC cover.
Spot Lamp Assembly
INSTALLATION
CAUTION: Make sure that the master spot lamp feed or either the left or right spot lamp feed are removed from the Power Distribution
Center (PDC) before performing service on the spot lamps.
1. Install the spot lamp outer tube and mounting bracket to the A-pillar.
2. Install the screws retaining the spot lamp mounting bracket to the A-pillar and tighten to 33 Nm (29 in. lbs.).
3. Carefully lift the edge of the secondary door seal along the windshield pillar to expose the spot lamp outer tube and apply a small amount of clear
silicone sealer to the base of the outer tube.
