300 V6-3.5L (2008)
Power Steering Line/Hose: Service and Repair
Power Steering Hoses - Installation
Pressure Hose - All-Wheel-Drive
ALL-WHEEL-DRIVE
1. Install pressure hose in engine compartment from underneath.
NOTE: Always use a NEW O-ring on the end of the pressure or return hose at the gear.
2. Lubricate NEW O-ring on steering gear end of pressure hose with clean power steering fluid.
3. Insert pressure hose into steering gear (2) port and install tube nut (3). Do not tighten tube nut at this time.
4. Lubricate NEW O-ring on steering gear end of return hose with clean power steering fluid.
5. Insert return hose into steering gear (2) port and install tube nut (1). Do not tighten tube nut at this time.
6. Route pressure hose along left side of engine cradle. Install screw through routing clamp and secure hose to left side of engine cradle.
7. Route pressure hose along front of engine cradle. Install screw through routing clamp (1) and secure hose to front of engine cradle (2).