300 V6-3.5L (2008)
8. Tighten pressure (3) and return (1) hose tube nuts at steering gear (2) to 47 Nm (35 ft. lbs.).
9. Install belly pan. See: Body and Frame/Exterior Moulding / Trim/Underbody Cover/Service and Repair/Belly Pan - Installation
10. Lower vehicle.
NOTE: Always use a NEW O-ring on the end of the pressure hose.
11. Lubricate NEW O-ring on power steering pump end of pressure hose with clean power steering fluid.
12. 3.5L Engine - Install pressure hose (2) to pump (1). Tighten pressure hose tube nut to 47 Nm (35 ft. lbs.).
13. 5.7L/6.1L Engine - Install pressure hose (2) to pump (1). Tighten pressure hose tube nut to 47 Nm (35 ft. lbs.).
14. Install air cleaner housing and inlet tube. See: Filters/Air Cleaner Housing/Service and Repair/Air Cleaner Housing - Installation
