300 V6-3.5L (2008)
8. Slide return hose (1) onto end of cooler (2). Install clamp securing hose in place.
9. Install belly pan. See: Body and Frame/Exterior Moulding / Trim/Underbody Cover/Service and Repair/Belly Pan - Installation
10. Lower vehicle.
11. Connect battery negative cable (2) to battery post. It is important that this is performed properly. See: Starting and Charging/Battery/Service and
Repair/Procedures/Battery Reconnection
12. Fill and bleed power steering system. See: Steering and Suspension/Steering/Power Steering/Power Steering Bleeding/Service and Repair
Return Hose - Gear To Cooler - RWD
GEAR TO COOLER - RWD
1. Route cooler end of return hose (2) over steering gear from rear using the reverse of how it was removed.