300 V6-3.5L (2008)
5. Unlock and disconnect the electrical connector from EGR valve.
6. Remove the wiper module, See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Wiper Module - Removal.
7. Remove shock tower brace and relocate.
8. Remove the upper intake manifold, See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair/Intake Manifold - Removal.
9. EGR valve (2) and tube (1).
10. Remove tube bolts (1) to EGR valve (3).
11. Remove tube (1) from intake manifold.
12. When removing EGR upper tube assembly being careful not to drop the silicone rubber seals in the intake manifold. Clean gasket surfaces on the
EGR valve. Note that any loose dirt can lodge between the pintle and the seat and cause valve leakage that will give a rough idle and depressed
