300 V6-3.5L (2008)
Tire Pressure Monitor Receiver / Transponder: Service and Repair
TPM Transponder - Installation
Front
FRONT
1. Position transponder (2) against front fascia (4) and install mounting screw (3).
2. Connect wiring harness connector (1) at transponder (2).
3. Install wheelhouse splash shield and all components removed to access it. See: Body and Frame/Fender/Front Fender/Front Fender Liner/Service
and Repair/Installation
4. Perform TPM Diagnostic Verification Test. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic
Trouble Code Tests and Associated Procedures/Verification Tests/Tire Pressure Monitor (TPM) Verification Test
Rear
REAR
1. Position transponder (2) on body seam flange (4) and install mounting nuts (1).
2. Connect wiring harness connector (3) at transponder (2).
3. Install wheelhouse splash shield and all components removed to access it. See: Body and Frame/Fender/Rear Fender/Rear Fender Liner/Service
and Repair/Installation
4. Perform TPM Diagnostic Verification Test. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic
Trouble Code Tests and Associated Procedures/Verification Tests/Tire Pressure Monitor (TPM) Verification Test