Front Steering Knuckle Removal and Replacement
8. Remove Support Clamp (1) from knuckle (3).
Assembly - Ball Joint - RWD
ASSEMBLY - BALL JOINT
NOTE: To perform this procedure it works best to mount Press (3), Special Tool C-4212F, in a vise and hold the component in your hands.
1. Place Installer (1), Special Tool 9320-4, into cup area of Press (3), Special Tool C-4212F, as shown and tighten set screw.
2. Place Remover (2), Special Tool 9320-3, onto end of screw-drive of Press (3), Special Tool C-4212F, as shown.Note: This is the reverse of how
Remover is installed on screw-drive for removal.
3. Start NEW ball joint (1) into bore of knuckle (2).
