300 V6-3.5L (2008)
15. Connect battery negative cable (2) to battery post. It is important that this is performed properly. See: Starting and Charging/Battery/Service and
Repair/Procedures/Battery Reconnection
16. Fill and bleed power steering system. See: Power Steering Bleeding/Service and Repair
Pressure Hose - Rear-Wheel-Drive
REAR-WHEEL-DRIVE
1. Install pressure hose in engine compartment from underneath.
NOTE: Always use a NEW O-ring on the end of the pressure hose.
2. Lubricate NEW O-ring on steering gear end of pressure hose with clean power steering fluid.
3. Install pressure hose (2) to steering gear (1). Do not tighten tube nut at this time.
