300 V6-3.5L (2008)
6. Route cooler end of return hose (1) under headlamp mounting crossmember (3) as shown.
7. Place hose in routing clip (2) on cooling module.
8. Slide return hose (1) onto end of cooler (2). Install clamp securing hose in place.
9. Install belly pan. See: Body and Frame/Exterior Moulding / Trim/Underbody Cover/Service and Repair/Belly Pan - Installation
10. Lower vehicle.
11. Connect battery negative cable (2) to battery post. It is important that this is performed properly. See: Starting and Charging/Battery/Service and
Repair/Procedures/Battery Reconnection
12. Fill and bleed power steering system. See: Power Steering Bleeding/Service and Repair
Supply Hose
INSTALLATION
