300 V6-3.5L (2008)
NOTE: Always use a NEW O-ring on the ends of the steering hoses.
4. Lubricate NEW O-ring on end of pressure hose with clean power steering fluid.
5. Install pressure hose (3) to steering gear (2). Tighten tube nut to 47 Nm (35 ft. lbs.).
6. Lubricate NEW O-ring on end of return hose with clean power steering fluid.
7. Install return hose (1) to steering gear (2). Tighten tube nut to 47 Nm (35 ft. lbs.).
8. Align splines and install steering coupling to steering gear shaft. Install NEW pinch bolt. Tighten bolt to 54 Nm (40 ft. lbs.) torque.
9. Install each outer tie rod (2) end to its knuckle (3). Install nut (1) and tighten to 85 Nm (63 ft. lbs.).
10. Install tire and wheel assemblies (1). Tighten wheel mounting nuts (3) to 150 Nm (110 ft. lbs.) (Police - 190 Nm (140 ft. lbs.)). See: Wheels and
Tires/Service and Repair/Removal and Replacement/Tires and Wheels - Installation
11. Lower vehicle.
