300 V6-3.5L (2008)
3. Install tire and wheel assembly (1). Tighten wheel mounting nuts (3) to 150 Nm (110 ft. lbs.) (Police - 190 Nm (140 ft. lbs.)). See: Wheels and
Tires/Service and Repair/Removal and Replacement/Tires and Wheels - Installation
4. Lower vehicle.
5. Position vehicle on alignment rack/drive-on lift. Raise vehicle as necessary to access link fasteners.
6. Tighten compression link fasteners to:
-
Bolt at crossmember - 85 Nm (63 ft. lbs.).
-
Bolt at knuckle - 81 Nm (60 ft. lbs.).
7. Perform wheel alignment. See: Alignment/Service and Repair
Spring Link
SPRING LINK
1. Raise and support vehicle. See: Wheels and Tires/Vehicle Lifting/Service and Repair
2. Access and remove rear spring. See: Suspension Spring ( Coil / Leaf )/Service and Repair/Rear Spring - Removal
3. Export Only - If servicing right spring link, disconnect headlamp leveling sensor (1) link at spring link (3).