300 V6-3.5L (2008)
13. If removed, install fuel filler tube. See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Tank/Fuel Filler Neck/Service and
Repair/Installation
14. Lower vehicle until front tires contact floor but rear is still suspended. Place jack stands under each rear suspension spring link. Place an
appropriate wooden block between stand and link to avoid damaging spring link, then lower vehicle until full vehicle weight is supported by
suspension.
15. Tighten camber link fasteners (2) to:
-
Bolt at crossmember - 85 Nm (63 ft. lbs.).
-
Bolt nut at knuckle - 98 Nm (72 ft. lbs.).
