300 V6-3.5L (2008)
NOTE: Due to short travel and low spring tension, it is not necessary to lock-out parking brake lever to service parking brake components.
40. Connect front parking brake cable (5) at connector (3) to right rear parking brake cable (4).
41. Install rear exhaust system (2) (dual-outlet exhaust shown in figure). See: Engine, Cooling and Exhaust/Exhaust System/Muffler/Service and
Repair/Muffler - Installation
42. Install tire and wheel assemblies (1). Tighten wheel mounting nuts (3) to 150 Nm (110 ft. lbs.) (Police - 190 Nm (140 ft. lbs.)). See: Wheels and
Tires/Service and Repair/Removal and Replacement/Tires and Wheels - Installation
43. Lower vehicle until rear wheels are just above floor level.
44. Apply parking brake lever. Release lever, then reapply.
45. Check to make sure rear wheels will not rotate with lever applied.
46. Lower vehicle.
