300 V6-3.5L (2008)
Wheel Fastener: Service and Repair
Studs - Removal
Front
REMOVAL
NOTE: Before proceeding, See: Brakes and Traction Control/Service Precautions/Brakes - Caution.
CAUTION: Wheel mounting studs MUST NOT be hammered out of hub flange of hub and bearing assembly. If a stud is removed by
hammering it out, damage to hub and bearing assembly will occur leading to premature bearing failure.
1. Raise and support vehicle. See: Vehicle Lifting/Service and Repair
2. Remove front wheel and tire assembly. See: Service and Repair/Removal and Replacement/Tires and Wheels - Removal
3. Access and remove front brake rotor. See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and
Replacement/Brake Rotor - Removal
4. On wheel mounting stud to be removed, install a wheel mounting (lug) nut (1) far enough so the threads on the stud are even with end of nut.
Install Remover (3), Special Tool C-4150A, on hub and bearing flange and wheel stud (5).
5. Tighten screw on Remover, pushing wheel stud (5) out of hub flange. Once shoulder of wheel stud is past flange, remove special tool. Remove nut
from stud and remove stud from hub flange.
Rear
REMOVAL
NOTE: Before proceeding, See: Brakes and Traction Control/Service Precautions/Brakes - Caution.
CAUTION: Wheel mounting studs MUST NOT be hammered out of hub flange of hub and bearing assembly. If a stud is removed by
hammering it out, damage to hub and bearing assembly will occur leading to premature bearing failure.
1. Raise and support vehicle. See: Vehicle Lifting/Service and Repair
2. Remove rear wheel and tire assembly. See: Service and Repair/Removal and Replacement/Tires and Wheels - Removal
3. Access and remove rear brake rotor. See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and
Replacement/Brake Rotor - Removal
