300 V6-3.5L (2008)
38. On each side of vehicle, slide an axle half shaft (2) through hub and bearing and install hub nut (1). Do not tighten hub nuts at this time.
39. Install rear axle differential. See: Service and Repair/Removal and Replacement/Rear Axle - 198RII/Installation See: Service and Repair/Removal
and Replacement/Rear Axle - 210RII/Installation See: Service and Repair/Removal and Replacement/Rear Axle - 215RII/Installation
40. While a helper applies brakes to keep hub from turning, tighten hub nut to 213 Nm (157 ft. lbs.).
41. Install rear exhaust system (2) (dual-outlet exhaust shown in figure).