300 V6-3.5L (2008)
Seals and Gaskets: Service and Repair
Seal-Rear Output Shaft
Removal
REMOVAL
1. Remove the rear propeller shaft.See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Propeller Shaft -
Removal
2. Using Spanner Wrench 6958 (1), remove the rear output shaft flange (2) nut.
3. Using a suitable 2 or 3 jaw puller (1), remove the rear output shaft flange (2).
4. Using a suitable pry tool (1), remove the output shaft seal (2) from the transfer case (2).
Installation
INSTALLATION