300 V6-3.5L VIN G (2005)
7. Remove the tape securing the door glass in its full up position, then lower the glass to engage it into the two window regulator glass clamps (3).
8. Using the regulator, lower the glass far enough to access the two window regulator glass clamp screws (2).
9. Tighten the screw in each of the glass clamps. Tighten the screws to 10 N.m (90 in.lbs.).
10. With the upper screw (1) hand-started into the pull cup bracket (2), position the screw into the keyed hole on the inside of the front door.
11. Install and tighten the screw (3) that secures the bottom of the pull cup bracket and the bottom of the window regulator rear rail to the inside of the
front door. Tighten the screw to 11 N.m (100 in.lbs.).
12. Tighten the screw that secures the top of the pull cup bracket to the inside of the front door. Tighten the screw to 10 N.m (90 in.lbs.).
13. Install the watershield onto the inside of the front door.
14. Install the speaker onto the inside of the front door.
15. Install the trim panel onto the inside of the front door.
