300 SRT-8 V8-6.1L (2008)
Front Door Exterior Handle: Service and Repair
Front Door Exterior Handle - Installation
INSTALLATION
1. Position the exterior handle (1) to the mounting holes on the outside of the door.
2. From the inside of the door, install and tighten the three screws (2) that secure that exterior handle to the door. Tighten the screws to 5 Nm (44 in.
lbs.).
3. For the driver side handle only, reach up into the back of the door shell to engage the lock actuator link (3) to the lock cylinder and snap the plastic
clip over the link to secure it to the lock cylinder.
4. Reach up into the back of the door shell to engage the latch release link (2) to the exterior door handle (1) and snap the plastic clip over the link to
secure it to the handle.
