300 SRT-8 V8-6.1L (2008)
NOTE: Before installing coil spring, make sure isolators (1 and 5) are completely installed on ends of spring.
27. Install coil spring (2) with isolators into spring pocket of spring link fitting the lower isolator to the shape of the pocket, then align top of spring
with body mount.
28. Carefully raise jack, guiding coil spring and lower end of shock absorber (1) into mounted positions. Once shock absorber (1) lower mounting hole
lines up with hole in spring link (3), stop jacking.
29. Install lower shock mounting bolt (2) and nut (4). Do not tighten at this time.
30. If vehicle is equipped with AWD, insert spacers (1) on top of left crossmember mount bushings (2) before crossmember is raised into place.
NOTE: There are four crossmember mounting bolts. Rear mounting bolts (2) are longer than front mounting bolts (3). Do not interchange
mounting bolts.
