300 SRT-8 V8-6.1L (2008)
9. Connect battery negative cable (2) to battery post. It is important that this is performed properly. See: Starting and Charging/Battery/Service and
Repair/Procedures/Battery Reconnection
10. Bleed (1) base brake hydraulic system as necessary. See: Brake Bleeding
11. Road test vehicle making several stops to wear off any foreign material on brakes and to seat brake shoes.
Front - SRT8
INSTALLATION
CAUTION: Always inspect brake pads before installing disc brake caliper and replace as necessary. See: Brake Pad/Service and
Repair/Procedures/Brake Pads - Inspection
1. Completely retract caliper pistons back into bores of caliper. Use hand pressure or a C-clamp may also be used to retract pistons, first placing a
wood block or used brake pad (not to be reused) over pistons before installing C-clamp to avoid damaging piston.
2. If brake pads need to be installed in caliper before installation, See: Brake Pad/Service and Repair/Removal and Replacement/Brake Pads -
Installation.
