300 SRT-8 V8-6.1L (2008)
10. Install tire and wheel assembly (1). Tighten wheel mounting nuts (3) to 150 Nm (110 ft. lbs.) torque. See: Maintenance/Wheels and Tires/Service
and Repair/Removal and Replacement/Tires and Wheels - Installation
11. Lower vehicle.
12. Pump brake pedal several times to set pads to caliper and brake rotor.
13. Check and adjust brake fluid level in reservoir (1). See: Hydraulic System/Brake Fluid/Service and Repair
CAUTION: When NEW brake pads have been installed, keep in mind that braking effectiveness might be somewhat reduced during the
first brake applications following installation.
NOTE: When NEW brake pads are installed, they must be burnished (seated) to the rotor. This must be done to ensure the proper performance
of the replacement brake pads.
14. Road test vehicle making several stops to wear off any foreign material on brakes and to seat brake pad linings. NEW brake pads need to be
burnished properly. See: Procedures/Brake Pads - Brake Pad Burnishing
