300 SRT-8 V8-6.1L (2008)
6. Install tire and wheel assembly (1). Tighten wheel mounting nuts (3) to 150 Nm (110 ft. lbs.) torque. See: Maintenance/Wheels and Tires/Service
and Repair/Removal and Replacement/Tires and Wheels - Installation
7. Lower vehicle.
8. Pump brake pedal several times to ensure vehicle has a firm brake pedal before moving vehicle.
9. Check and adjust brake fluid level in reservoir (1) as necessary.
CAUTION: If NEW brake rotors or pads have been installed, keep in mind that braking effectiveness might be somewhat reduced during
the first brake applications following installation.
10. Road test vehicle making several stops to wear off any foreign material on brakes and to seat brake pads. If NEW brake pads are installed, they
need to be properly burnished. See: Brake Pad/Service and Repair/Procedures/Brake Pads - Brake Pad Burnishing
