300 SRT-8 V8-6.1L (2008)
9. Connect battery negative cable (2) to battery post. It is important that this is performed properly. See: Starting and Charging/Battery/Service and
Repair/Procedures/Battery Reconnection
10. Bleed (1) base brake hydraulic system as necessary. See: Brake Bleeding
11. Road test vehicle making several stops to wear off any foreign material on brakes and to seat brake shoes.
Rear-Wheel-Drive
REAR-WHEEL-DRIVE
CAUTION: Always inspect brake pads before installing disc brake caliper and replace as necessary. See: Disc Brake System/Brake Pad/Service
and Repair/Procedures/Brake Pads - Inspection
1. Completely retract caliper pistons back into bores of caliper. Use hand pressure or a C-clamp may also be used to retract pistons, first placing a
wood block over piston before installing C-clamp to avoid damaging piston.
CAUTION: Use care when installing caliper onto disc brake adapter to avoid damaging boots on caliper guide pins.
2. Push caliper guide pins into caliper adapter to clear caliper mounting bosses when installing.
