300 SRT-8 V8-6.1L (2008)
4. Route pressure hose along right side of engine cradle. Position pressure hose (1) routing clamp over return hose (2) routing clamp, then install
screw (4) securing hoses to right side of engine cradle (3).
5. Route pressure hose along front of engine cradle. Install screw (5) through routing clamp securing hose to front of engine cradle (3).
6. Tighten pressure hose tube nut at steering gear to 47 Nm (35 ft. lbs.).
7. Install belly pan. See: Body and Frame/Exterior Moulding / Trim/Underbody Cover/Service and Repair/Belly Pan - Installation
8. Lower vehicle.
NOTE: Always use a NEW O-ring on the end of the pressure hose.
9. Lubricate NEW O-ring on power steering pump end of pressure hose with clean power steering fluid.
10. 2.7L/3.5L Engines - Install pressure hose (2) to pump (1). Tighten pressure hose tube nut to 47 Nm (35 ft. lbs.).
