300 SRT-8 V8-6.1L (2008)
1. Install cooler end of return hose (3) from engine compartment side, under headlamp mounting crossmember as shown.
2. Place hose in routing clip (4) on headlamp mounting crossmember.
NOTE: If a lengthwise paint stripe appears on the return hose (3) near the end, position that paint stripe at the top (12 O'clock position) when
installed on the cooler. This positioning must be done to ensure proper hose routing.
3. Slide return hose (3) onto end of cooler (1). Install clamp securing hose in place.
4. Slide return hose (1) onto reservoir (2). Install clamp securing hose in place.
5. Install upper radiator closure panels.
6. Install air cleaner housing and inlet tube. See: Filters/Air Cleaner Housing/Service and Repair/Air Cleaner Housing - Installation
