300 SRT-8 V8-6.1L (2008)
8. Loosen each hub and bearing mounting bolt (2) a turn or two at a time while pulling outward on hub and bearing to avoid bolt contact with half
shaft outer joint. Once removed from threads in hub and bearing (but not knuckle), allow bolts to stay in and protrude through knuckle and brake
support plate to keep brake support plate in place when hub and bearing is removed.
9. Slide hub and bearing off knuckle and half shaft.
Hub and Bearing - SRT8
HUB AND BEARING - SRT8
1. Raise and support vehicle. See: Vehicle Lifting/Service and Repair
2. Remove wheel mounting nuts (3), then tire and wheel assembly (1).
3. While a helper applies brakes to keep hub from rotating, remove hub nut (1) from the half shaft (2).
