300 SRT-8 V8-6.1L (2008)
7. Loosen the cam bolt nut securing the toe link to the rear crossmember (front of rear crossmember) just enough to rotate the cam bolt (1).
NOTE: When adjusting rear toe, the eccentric lobes on the toe adjustment cam bolts and washers are not to be facing downward. The lobes
should only be facing upward or up to 90° to one side or the other from the 12 O'clock position.
8. Rotate the cam bolt head on the opposite side (rear) of the crossmember in either direction until the preferred specification is obtained. See:
Specifications
9. While holding the cam bolt (1) from turning, tighten the cam bolt nut to specifications.
10. Adjust rear toe on opposite side of vehicle using above procedure as necessary.
11. Once rear toe is set, proceed to FRONT TOE to set the vehicle's front toe.
FRONT TOE
NOTE: Perform the following procedure to each side of the vehicle as necessary.
