300 SRT-8 V8-6.1L (2008)
3. Remove fuel filler tube. See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Tank/Fuel Filler Neck/Service and Repair/Removal
4. Position an extra pair of jack stands under and support forward end of engine cradle to help stabilize vehicle during rear suspension
removal/installation.
5. Perform following if vehicle is equipped with dual-exhaust.
a. Position under-hoist utility jack or stand several inches below exhaust at muffler.
b. Disconnect exhaust isolators at muffler and resonators hangers.
c. Lower exhaust down to rest upon top of jack or stand placed below muffler.
6. Position under-hoist utility jack or transmission jack (3) under center of rear axle differential (1). Raise jack head to contact differential and secure
in place.
7. Remove shock absorber (1) lower mounting bolt (2) and nut (4).
