300 SRT-8 V8-6.1L (2008)
CAUTION: In following step, use care not to damage ball joint seal boot while sliding Puller, Special Tool 9360, into place past seal boot.
21. Using Puller (2), Special Tool 9360 Ball Joint Removal tool, separate ball joint stud from knuckle.
22. Remove tool.
23. Remove left and right engine mount nut.
24. Remove nut (1) from end of ball joint stud.
25. On each side of vehicle, remove bolts (2) fastening stabilizer bar isolator retainer (3) in place.
26. Remove stabilizer bar with isolators and retainers from vehicle.
27. Support the engine cradle (special tool #8534 Engine Support Fixture) with a suitable lifting device.
28. Using a grease pencil or equivalent, mark the position of the engine cradle to aid installation.
29. Remove the four engine cradle bolts and lower the cradle.
30. Remove the control arms, if required.
