300 SRT-8 V8-6.1L (2008)
6. Tighten engine mount nuts to 60 Nm (44 ft. lbs.).
7. Tighten left and right ball joint nut (4) to 122 Nm (90 ft. lbs.) attaching lower control arm ball joint stud to knuckle (3).
8. Install steering gear (1) and support from the exhaust system.See: Steering/Steering Gear/Service and Repair/Steering Gear - Installation
9. Install steering gear lower mounting bolts (2 and 3). Tighten to 142 Nm (105 ft. lbs.).
10. Install steering gear upper mounting bolt (4) and nut.
11. Install heat shield (3) and mounting screws above each inner tie rod bellow.
