300 SRT-8 V8-6.1L (2008)
Rear Cross-Member: Service and Repair
Installation
INSTALLATION
1. Install rear crossmember (1) on jack (2) head in same position in which it was removed and secure in place.
2. Carefully place one side knuckle with links and parking brake cable attached as an assembly into mounted position on rear suspension
crossmember. Install nut and bolt (2) mounting camber link to crossmember (1) to hold assembly in place. Do not tighten at this time.
3. Carefully place opposite side knuckle with links and parking brake cable attached as an assembly into mounted position on rear suspension
crossmember. Install nut and bolt (2) mounting camber link to crossmember (1) to hold assembly in place. Do not tighten at this time.
4. On each side of crossmember, install nut and bolt (4) mounting each tension link to crossmember (1). Do not tighten at this time.
