300 SRT-8 V8-6.1L (2008)
198RII/Installation See: Transmission and Drivetrain/Differential Assembly/Service and Repair/Removal and Replacement/Rear Axle -
210RII/Installation See: Transmission and Drivetrain/Differential Assembly/Service and Repair/Removal and Replacement/Rear Axle -
215RII/Installation
54. While a helper applies brakes to keep hub from turning, tighten hub nut to 213 Nm (157 ft. lbs.).
55. Install rear exhaust system (2) (dual-outlet exhaust shown in figure).
56. Lower vehicle until front tires contact floor but rear is still suspended. Place jack stands under each rear suspension spring link. Place an
appropriate wooden block between stand and link to avoid damaging spring link, then lower vehicle until full vehicle weight is supported by
suspension.
