300 SRT-8 V8-6.1L (2008)
NOTE: Before installing hub and bearing on end of axle half shaft, ensure isolation washer is present on end of half shaft. Inspect washer
making sure it is not worn or damaged. Washer can be installed in either direction on shaft.
2. Place knuckle (3) over lower ball joint stud and guide hub and bearing (2) onto axle half shaft (1).
3. Start NEW nut (4) on lower ball joint stud. Do not tighten at this time.
CAUTION: It is important to tighten nut as described in following step to avoid damaging ball stud joint.
4. Place upper ball joint stud (1) through hole in top of knuckle and install nut (4). Tighten nut by holding ball joint stud with a hex wrench while
turning nut with a wrench. Tighten nut using crow foot wrench on torque wrench to 47 Nm + 90° turn (35 ft. lbs. + 90° turn).