300 SRT-8 V8-6.1L (2008)
7. Thread Remover Bolt 9361-3 (1) into tapped knuckle sleeve.
8. Rotate Nut down, matching Sleeve angled end with angled face of knuckle.
9. Continue to rotate Nut until knuckle sleeve is removed from knuckle. Discard knuckle sleeve; replace it with new upon installation.
10. Remove bolt and nut (1) fastening spring link (4) to crossmember.
11. Remove spring link (4).
Spring Link - SRT8
SPRING LINK - SRT8
1. Access and remove rear brake rotor on side of repair. See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and
Repair/Removal and Replacement/Brake Rotor - Removal
2. Access and remove rear spring on side of repair. See: Suspension Spring ( Coil / Leaf )/Service and Repair/Rear Spring - Removal
