300 SRT-8 V8-6.1L VIN W (2005)
Engine Block Heater: Service and Repair
ENGINE BLOCK HEATER
REMOVAL
1. Raise vehicle on hoist.
2. Detach power cord plug from block heater (1).
3. Remove block heater attaching screw located below heater terminals.
4. Remove block heater from cylinder block (2).
INSTALLATION
1. Thoroughly clean cylinder block heater cavity.
2. Insert heater assembly (1) into block (2) with mounting hole is located below heater terminals.
3. Install mounting screw and tighten to 12 Nm (105 inch lbs.).
4. Attach power cord to heater.
CAUTION: To prevent damage, the power cord must be secured in its retainer clips, and not positioned so it could contact linkages or exhaust
manifolds.
5. Lower vehicle.
