300M V6-3.5L VIN G (2000)
6. Raise trim panel up over the door flange and being careful to hold the panel securely.
7. Disconnect the remote linkage from the door remote handle.
8. Remove the wire connect from the rear door speaker.
9. Disconnect power window switch wire connector.
10. Disconnect wiring harness clips from the trim panel.
11. Disconnect the courtesy lamp.
12. Remove trim panel from door.
INSTALLATION
1. Place trim panel in position on door.
2. Connect the courtesy lamp.
3. Connect the wiring harness clips to the trim panel.
4. Connect the power window switch wire harness connector.
5. Connect the rear door speaker wire connect.
6. Connect the remote handle linkage.
7. Install the water shield. Ensure that the water shield locator holes align. Ensure that the shield is sealed.
8. Place trim panel into channel retainer at top door.
9. Insert trim panel into channel retainer at top door.
10. Insert the forward four way alignment guide into position. Insert the rearward two way alignmen guide into position.
11. Install new retaining clips to attach door trim panel to door panel.
12. Engage retaining clips attach door trim panel.
13. Install three screws to the bottom of the door tighten screws 1.7 to 2.3 Nm (15 to 20 in. lbs) torque.
14. Install screw in the remote bezel.
15. Install screw in pull cup. Tighten screw 2.3 Nm (15 to 20 in. lbs.) torque.
16. Install pull cup and remote bezel trim plug equipped.
