300M V6-3.5L VIN G (2000)
7.
Mark the outline of the rear vinyl wrapped edge of trim panel on the sheet metal using a grease pencil (Figure 2).
8.
Remove door trim panel.
9.
If not completed in Step 5, drill a 1/8" pilot hole through the sheet metal inner panel at the location marked in Step 5 (Figure 3).
10.
Replace the (2) white clips at the rear of the trim panel with p/n 06504014 **('98-'00 Model Years).**
11.
Replace the (1) green clip at the front of the trim panel with p/n 06503204 **('98-'00 Model Years).**
NOTE:
LH VEHICLE DOOR TRIM PANEL CLIPS ARE NOT REUSABLE ON **"98-"00 M.Y.** ANYTIME A DOOR PANEL IS REMOVED THE
CLIPS MUST BE REPLACED.
