300M V6-3.5L VIN G (2000)
10.
Remove the outboard recliner paddle-to-seat back frame bolt (Figure 7).
11.
Remove the inboard recliner paddle-to-seat back frame bolt.
12.
Install one of the supplied bolts into the hole in the outboard recliner paddle (Figure 8) and then into the hole in the seat back frame. Tighten
the bolt (without the nut attached) to 90 in-lbs (10.2 N.m).
NOTE:
If the seat back frame threads are stripped, tighten the bolt as much as possible and then install and tighten the nut.
IMPORTANT:
Use the proper size torque wrench. Do NOT over tighten. Do not use a foot-pound torque wrench.
13.
Install one of the supplied nuts onto the bolt (Figure 8). While holding the bolt stationary, tighten the nut to 110 in-lbs (12.5 Nm).
14.
Install the other supplied bolt into the hole in the inboard recliner paddle (Figure 8) and then into the hole in the seat back frame. Tighten the
bolt (without the nut attached) to 90 in-lbs (10.2 N.m).
