300M V6-3.5L VIN G (2000)
Fig. 10 Dust Boot Removal
7. Remove the piston dust boot from the caliper and discard.
Removing Piston Seal From Caliper
8. Using a soft tool, such as a plastic trim stick, work piston seal out of its groove in caliper piston bore. Discard old seal. Do not use a screw driver
or other metal tool for this operation, because of the possibility of scratching piston bore or burring edges of seal groove.
9. Clean all parts using alcohol or a suitable solvent and wipe dry using only a lint free cloth. No lint residue can remain in caliper bore. Clean out all
drilled passages and bores. Whenever a caliper has been disassembled, a new boot and seal must be installed at assembly.