300M V6-3.5L VIN G (2000)
22. Remove the 2 screws securing the front park brake cable retainer bracket to the rear floor pan.
23. Remove 2 routing bracket screws securing front park brake cable to left side of the passenger compartment floor. One is at the base of the B-pillar
by the seat belt anchor bolt , and the other is below the park brake lever assembly on the floor pan.
24. Remove the rear bolt, and loosen the 2 front nuts on studs, securing the park brake lever assembly in place.
25. Lower the park brake lever assembly enough to gain access to the warning lamp ground wire connector. Remove the brake warning light ground
wire from the switch on the park brake lever assembly.
26. Continue to move park brake lever, with front park brake cable attached, downward, and remove both from vehicle together.
INSTALLATION
1. Install the park brake lever, with front cable, assembly back in vehicle by first running the front cable, starting from front to the rear, along the left
side of passenger compartment. Guide it into the hole at the rear of the floor pan.
2. Guiding the lever assembly up past the fuse junction block, position the park brake release cable into place. Also, reinstall the brake warning lamp
wire, through access hole in lever assembly, onto switch.
3. Position the lever assembly in its mounting place. Install the rear mounting bolt and tighten it to a torque of 27 Nm (19 ft. lbs.). Tighten the 2
mounting nuts to a torque of 27 Nm (19 ft. lbs.).
4. Ensure that the park brake cable is properly routed and install the two routing bracket screws.
5. Install the 2 screws securing the front park brake cable retainer bracket to the rear floor pan.
6. Reposition the carpeting in place.
